One drills a hole through the very center of the dent and inserts the hook at the end of the suction device which typically looks like a plunger.
Getting dents out of aluminum siding.
Push a metal screw into the hole far enough so that it becomes difficult to turn.
It doesn t take a lot.
Hammer off dolly for stress relieving is the best technique to avoid stretching aluminum.
Do not weld on aluminum unless you have had proper aluminum welding training.
Wipe down the aluminum trailer s dent to get it moist.
Dampen a rag in water.
How to fix small dents in aluminum siding drill a hole in it insert a sheet metal screw tug the washer putty the hole sand the spot prime and paint the repair.
Next pull on the screw with a pair of pliers.
Drill a couple of 1 8 inch holes in the part of the siding that contains the dent.
Don t use just any braising rod.
Sanding sponges work.
Very large dents can be fixed by actually pulling the dent into line with the rest of the sheet metal.
Repairing small dents 1.
Place a flat washer onto a sheet metal screw and then screw it part of the way into one of the holes you drilled.
Grip the head of the metal screw with.
Work slowly and stop the drill before.
Here s what to do.
Screw the 6 self tapping screw into the center of the dent.
Braising is totally different and anyone can do it with the proper aluminum braising rods.
Using boiling water to get car dents out duration.
Put on safety goggles.
Using sandpaper take off all the paint.
Play pause space step 2.
Hammering will leave hammer marks but if your really good at it you might be able to hammer it out and have it look decent.
Specially designed suction devices are sold in car repair stores for this purpose.
You want it where it s deepest.
Kirkham university aluminum fender dent repair duration.
How to repair a dent in an enclosed aluminum trailer step 1.
Pull back on the plunger to straighten the dent.
Place a plunger against the dent and push down to create suction.
Use pliers to pull the dent halfway up.
Slapping spoons and other techniques are also good ways to relieve stress and not damage the metal.
Use caution if you are standing on a ladder.
