Garage Door Sensor Not Working In Sunlight

The receiving sensor should mounted on the side of the garage door opening that receives the least amount of direct sunlight.

Garage door sensor not working in sunlight.

Sunlight can interfere with the sensors beam and cause them to act as if an object blocks them. It may be caused by sunlight. Many years ago sensors weren t common. Yeah that won t meet the requirements.

If you find the lights turned off in one or both the sensors it indicates that there is a problem in power supply. Look for small led lights on the sensors. Cutout cardboard and secure it around the sensors purchase sun shields that attach to the sensors move the sensors into the garage and out of the sun switch sides the sides of the sensors. Nowadays for safety reasons most garage doors have them.

Remove any debris dust or cobwebs from the electric eye lenses on each sensor with a clean rag. Direct sunlight creates interference with the sensors and may keep them from working properly. A common cause of a malfunctioning garage door sensor is lack of power supply. If you are in a hurry and need to get your garage door closed right away stand in such a way that you cast a shadow over your garage door s beam sensor but of course don t block the beam itself just the sunlight that is shining on it and then press your remote control so that your door will close.

If they re turned on in both the sensors then there is no issue with the power supply. Clutter or obstructions that block the sensor are the first problems to look for if your door won t close or in extreme cases open at all. Cycle the garage door through the opening and closing actions using the control on the garage wall. So if the problem seems to occur only during the daytime check to make sure the receiving eye.

First check the sensor lights. Depending on the brand.